Directive 1999/103/EC of the European Parliament and of the Council of 24 January 2000 amending Council Directive 80/181/EEC on the approximation of the laws of the Member States relating to units of measurement

1999L0103 — EN — 09.02.2000 — 000.002

This document is meant purely as a documentation tool and the institutions do not assume any liability for its contents

Corrected by:

DIRECTIVE 1999/103/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL

of 24 January 2000

amending Council Directive 80/181/EEC on the approximation of the laws of the Member States relating to units of measurement

THE EUROPEAN PARLIAMENT AND THE COUNCIL OF THE EUROPEAN UNION,

Having regard to the Treaty establishing the European Community, and in particular Article 95 thereof,

Having regard to the opinion from the commission (1),

Having regard to the opinion of the Economic and Social Committee (2),

Acting in accordance with the procedure referred to in Article 251 of the Treaty (3),

Whereas:

HAVE ADOPTED THIS DIRECTIVE:

Article 1

Directive 80/181/EEC is hereby amended as follows:

• 1.In Article 3(2), ‘31 December 1999’ shall be replaced by ‘31 December 2009’.

• 2.The following Article shall be added: ‘Article 6a Issues concerning the implementation of this Directive and, in particular, the matter of supplementary indications shall be further examined, and if necessary the appropriate measures adopted in accordance with the procedure referred to in Article 18 of Council Directive 71/316/EEC (6).’

• 3.The Annex shall be amended as follows: (a)In Chapter I, the text under the table in point 1.1.1 shall be replaced by the following: ‘Celsius temperature  t is defined as the difference  t = T – T 0 between the two thermodynamic temperatures  T and  T 0 where  T 0 = 273,15 K. An interval or difference of temperature may be expressed either in kelvins or in degrees Celsius. The unit “degree Celsius” is equal to the unit “kelvin”.’ (b)The definitions of the SI supplementary units following the table in point 1.2.1 shall be replaced by the following: ‘Unit of plane angle The radian is the angle between two radii of a circle which cut off on the circumference an arc equal in length to the radius. (International standard ISO 31 — 1: 1992) Unit of solid angle The steradian is the solid angle of a cone which, having its vertex in the centre of a sphere, cuts off on the surface of the sphere an area equal to that of a square with sides of length equal to the radius of the sphere. (International standard ISO 31 — 1: 1992).’ (c)The table in point 1.3 shall be replaced by the following: ‘Factor Prefix Symbol 1024 yotta Y 1021 zetta Z 1018 exa E 1015 peta P 1012 tera T 109 giga G 106 mega M 103 kilo k 102 hecto h 101 deca da 10-1 deci d 10-2 centi c 10-3 milli m 10-6 micro μ 10-9 nano n 10-12 pico p 10-15 femto f 10-18 atto a 10-21 zepto z 10-24 yocto y’ (d)Point 3 shall be replaced by the following: ‘3.   UNITS USED WITH THE SI, WHOSE VALUES IN SI ARE OBTAINED EXPERIMENTALLY Quantity Unit Name Symbol Definition Energy Electronvolt eV The electron volt is the kinetic energy acquired by an electron in passing through a potential difference of 1 volt in vaccum Mass Unified atomic mass unit u The unified atomic mass units is equal to 1/12 of the mass of an atom of the nuclide 12C.’ ‘Note:‘The prefixes and their symbols listed in 1.3 may be used in conjunction with these two units and with their symbols.

Article 2

Member States shall bring into force the laws, regulations and administrative provisions necessary to comply with this Directive before 9 February 2001. They shall forthwith inform the Commission thereof.

When Member States adopt these measures, they shall contain a reference to this Directive or shall be accompanied by such reference at the time of their official publication. Member States shall lay down the procedure for such reference.

Article 3

Without prejudice to Directive 80/181/EEC, Member States shall, after 31 December 1999, authorise or continue to authorise the use of the supplementary indications referred to in Article 3 of that Directive.

Article 4

This Directive shall enter into force on the day of its publication in the Official Journal of the European Communities.

(1) OJ C 89, 30.3.1999, p. 8.

(2) OJ C 169, 16.6.1999, p. 1.

(3) Opinion delivered on 15 December 1999 (not yet published in the Official Journal). Council Decision of 16 December 1999.

(4) OJ L 39, 15.2.1980, p. 40. Directive as last amended by Directive 89/617/EEC (JO L 357, 7.12.1989, p. 28).

(5) OJ L 202, 6.9.1971, p. 1.

(6) OJ L 202, 6.9.1971, p. 1.